To top up brake fluid, first locate the brake fluid reservoir under the hood of your car. Clean the area around the reservoir to prevent any dirt or debris from falling into the system. Open the reservoir cap and add the appropriate type of brake fluid until it reaches the "Max" line. To bleed the brake system, start by filling the reservoir with fresh brake fluid. Then, have a helper pump the brake pedal several times and hold it down while you open the bleeder valve on each brake caliper or wheel cylinder. As the fluid and air bubbles come out, close the valve and repeat the process until the brake pedal feels firm. Be sure to keep an eye on the fluid level in the reservoir and top it up as needed during the bleeding process. **

To top up the brake fluid in your car, first locate the brake fluid reservoir under the hood of your car. Make sure the car is parked on a level surface and the engine is cool before opening the reservoir. Remove the cap from the reservoir and check the fluid level. If it is low, add the appropriate type of brake fluid recommended in your car's manual until it reaches the "Full" line. Be careful not to overfill the reservoir. Once you have topped up the brake fluid, securely replace the cap and ensure it is tightly sealed. **

No, it is not safe to continue driving with worn brake pads and brake discs. Worn brake pads and discs can reduce the effectiveness of the braking system, leading to longer stopping distances and potentially causing a dangerous situation on the road. It is important to replace worn brake pads and discs promptly to ensure the safety of yourself and others on the road. **

Yes, a TÜV inspector does check brake pads and brake discs during a vehicle inspection. The inspector will visually inspect the brake pads and discs for wear and damage, and may also measure the thickness of the brake pads and the condition of the brake discs. This is an important part of the inspection to ensure that the vehicle's braking system is in good working condition and meets safety standards. If any issues are found with the brake pads or discs, the inspector will advise the vehicle owner to have them replaced. **

The need to replace brake discs and brake pads depends on their condition. If the brake pads are worn down to a thickness of 3mm or less, or if the brake discs are warped, scored, or have a thickness below the manufacturer's recommended minimum, then they should be replaced. Additionally, if there are any signs of brake pulsation, squealing, or grinding, it may indicate the need for replacement. It is important to have a professional mechanic inspect the brakes to determine if replacement is necessary for safe and efficient braking. **

To paint picks, you can start by cleaning them with a damp cloth to remove any dirt or debris. Next, you can use a primer specifically designed for metal surfaces to ensure the paint adheres properly. Once the primer is dry, you can use acrylic paint or spray paint to add color and design to the picks. Allow the paint to dry completely before using the picks for playing guitar. **

Double-sided picks are not necessary, but they can be useful for certain playing styles and techniques. They offer versatility by providing different tip shapes on each side, allowing for a variety of tones and playing options. Some guitarists prefer double-sided picks for their convenience and ability to switch between different playing styles without needing to change picks. Ultimately, whether double-sided picks are necessary depends on personal preference and playing style. **

To paint guitar picks, you can start by cleaning the surface of the pick with rubbing alcohol to remove any oils or dirt. Next, use acrylic paint or nail polish to carefully apply your desired design onto the pick. Allow the paint to dry completely before adding a clear sealant to protect the design. Once the sealant is dry, your painted guitar pick is ready to use! **